WORKING WITH
ROTOWASH
Attention
:
First remove mains plug
from socket
Emptying the soiled water
Lift out wastewater tray. When
refitting wastewater tray ensure that
springs are pressing on the tray.
Attention
Avoid touching the edge of the
stripperblade. It may cause injury.
Clean stripperblade regularly.
Stripperblade is removable and
should be renewed before it
becomes sharp and causes damage
to the drum through wear.
Changing brushes
Attention
:
First remove mains plug
from socket!
The brushes can be changed after
removing the brush axles.
Refit the brush axle from the cable
side of the machine
Thermorelay cut-out switch
Use the machine only with the
voltage supply stated on the type
plate. By overloading of the motor
the cut-out switch will interrupt the
mains supply. After approximately
30 seconds the cut-out button by
machine with stick handle and
on/off switch with thermo relay by
machines with loop handle can be
pushed in and the machine is again
ready for use.
On machines with a loop handle,
the On/Off switch is also the
Thermorelay, and can be reset
after 30 seconds by switching to
the “On” position.
1
2
